If the tomato plant is allowed to sag it is likely that the bottom trusses will come into contact with moisture, with the various disadvantages of this. To prevent this there are the so-called tomato support brackets. To accompany the plant at the beginning and at the end of the path the rotating side support bracket is obtainable. The tomato support bracket is obtainable in every,width and height, the cut size is based on these measurements. The cut size can be calculated: length = 2 x height + width + 2 bend height - 10 cm. If required we can assist you further with advice. The wire thicknesses 5 mm, 5.5 mm and 6 mm are standard obtainable. Deviating measurements on request.